Dab+ Operation - View Quest Retro DAB+ Guia De Funcionamiento

DAB+ Operation

1. Connect the mains power lead into the socket on the back of the radio
(DC in 5V) and plug the power adaptor into the mains power wall socket
and switch on. Switch to DAB+ mode, press "MODE" button repeatedly
until the display shows "Switch to DAB+". Your radio will automatically
begin to Quick SCAN DAB+ stations. A progressive bar will show the
progress of the scan and the number of stations found during the scan will
also be displayed. The stations scanned will be stored automatically when
the scan is complete. The number of stations scanned will also be
displayed at the upper right corner of the screen. If there's no signal, "NO
Signal" will be shown.
2. The first station available will be played automatically.
3. You can press " " or "
4. DAB+ scan modes press "
longer, it will FULL SCAN.
5. Press "PREV" and "NEXT" to scroll up or down to seek for your favorite
stations.
6. Press "VOL+" or "VOL-" to adjust the volume.
7. To store the present station, press "PRE" button to activate store
function. "Preset Empty 1" will be displayed on lower line of the screen,
and the number 1 will flash. Press "
numbered preset locations (1-10), press "
Frequency will be displayed on the upper line. "Preset x Stored" will be
shown on the lower line of the screen to indicate if you store the station
successfully. 10 stations can be stored in total. To tune to a preset DAB+
station, press "PRE" button, then use "
the preset stations. Press "ENTER" button to confirm when you see the
station you would like to listen. The radio will tune to that station and begin
to play.
8. In DAB+ mode the radio will synchronize with the time and date of the
station.
9. In DAB+ mode press "INFO" button, the information such as DLS,
station name, time and date, frequency, bit rate, signal quality will be
displayed.
10. In DAB+ mode press "
manual. Press " " and "
and select the stations you would like to listen. Press "
confirm the channel, then press "
stations in this channel, press "
selected.
" button to switch among stations stored.
" shortly, it will Quick SCAN. Press it
" and " " to scroll through the
" button to store the station.
" and " " to scroll through
" button longer and enter into scan by
" button to scroll through channel 5A-13F
" and " " to scroll through
" button enter into the station you
GB
" button to
3