System Operation - View Quest Retro DAB+ Guia De Funcionamiento

IPOD MODE OPERATION
1. Press "MODE" to switch into IPOD mode. If there's no iPod or iPhone
connected, "iPod Disconnected" will be displayed on the screen. Insert
iPod or iPhone into the 30 Pin connector, the screen will show "iPod
Connected" and begin to display music in your iPod or iPhone.
2. Press " " or " " to play previous or next track.
3. Press " " button to pause or play the track.
4. Press and hold " " button to search the current track using high
speed rewind. It will stop and play again when you release the button.
5. Press and hold " " button to search the current track using high
speed forward. It will stop and play again after you release the button.
6. Press "VOL+" or "VOL-" to adjust volume.
AUX-IN MODE OPERATION
1 Press "MODE" button to switch into AUX-IN mode, plug the aux-in cable
into the 3.5mm AUX-IN jack at the back of the radio. It will play the music
from external audio devices.
2 Press "VOL+" or "VOL-" to adjust volume

SYSTEM OPERATION

1 Factory reset. In working mode, make a long press of "MODE" button,
"Press Enter Key to Reset" will be displayed on the screen. Then press
" " to confirm the factory reset until "System Reset OK" shows up.
2. In working mode, make a long press of "INFO" button to check the
software version.
Alarm clock function
This unit can set two alarms. In working or standby mode, make a short
press of "SNOOZE" button. Press once shows ALARM1. Press twice
shows ALARM2, alarm will ring 1 hour. It can wake up to DAB, FM, IPOD,
BEEP Tone1, BEEP Tone2. SNOOZE lasts 5 minutes.
GB
5