View Quest Retro DAB+ Guia De Funcionamiento página 5

FM MODE operation
1. Press "MODE" button and switch into FM mode. At the first time FM
GB
frequency "87.5MHz." will be displayed on the screen.
2. Scan stations by manual, press "
stations by 0.05MHZ until you get your favorite stations.
3. To autoscan stations, press "
station signal is available, scan will stop automatically and play this station.
Make press "
" button longer, it will search stations downward. If
station signal is available, scan will stop automatically and play this
station.
4. If you know which frequency you going to listen to, you can press "
button to search stations upward quickly to get targeted frequency. It will
stop scanning if you stop pressing and play the stations selected.
5. Press " " button to search stations downward quickly to get targeted
frequency. It will stop scanning if you stop pressing and play the station
selected.
6. To store the currently played station, make a long press of "PRE" button
to activate store function. "Preset Empty 1" will be shown on the lower line
of the screen, and number "1" will flash. Press "
numbered location to store, then press "
Frequency will be displayed on the upper line of the screen, and "Preset x
Stored" will be displayed on the lower line. 10 stations can be stored in
total. Press "PRE" to activate the function of listening stations stored.
Then press " " or "
" " button to confirm, the station selected will be played.
7. In FM mode, press "INFO" button to display the information such as
RDS, audio type, station frequency, time and date, signal quality, program
text, program type.
8. In FM mode, press "
select between Stereo and Mono.
9. In FM mode, when received RDS information, the radio will synchronize
with the time and date of the station automatically.
10. Press "VOL+" or "VOL-" to adjust volume.
4
" or " " button shortly to adjust
" button to search stations upward. If
" to store the station.
" to select numbered locations. After pressing
" button to switch among audio types, you can
"
" or " " to select