Preparation Before Use - Daitsu APU-DA300 Manual De Usuario

PREPARATION BEFORE USE

Host computer preparation
Before initial use of the product, it is necessary
to rip off the sealing plas tic bag of the fi lter
subas sembly.
Then it can be energ ized and operated.
1.Open and remove the front panel.
2.Remove the dust collector.
3.Remove HIMOP grid.
4.Take out the fi lter subassembly from the
plastic bag and remove the sealing plastic fi lm.
5.Mount the fi lter subassembly to HIMOP grid.
6.Assemble the unit according to the steps of 3,
2, 1 mentioned above
Prepare remote control
1. Prepare remote control
Open the battery cover on the back of the remote
control, place the battery in the circular tank, pay
attention to positive and negative poles, plug back the
remote control and then it can be used.
2. Use the remote control
Please put the remote control pointing to the receiver
window in operation.
The remote control should be used in the effective
range.
Make sure there is no obstruction between the remote
control and air cleaner, otherwise it will affect the
signal transduction.
All manuals and user guides at all-guides.com
Note: when instilling the fi lter
subassembly ensure that the blue
side is outward.
Press
1
Remove the sealing
plsastic fi lm
HIMOP
grid
3
Note: Protect the jut on the back of
the front panel if it is damaged the
unit can not work.
fi lter back of
subassemblyr ront
panel
This side is
5
blue.
3
1
2
4
Dust
collector
2
4
No damage!
6
Battery
24