Temperature Setting; Time Setting - Melchioni Family I-WARM ROBOT Manual De Uso

All manuals and user guides at all-guides.com
•
On status of standby, touch "MODE" for one time, LOW mode will be set and "Low",
(with small fire icon) will flash. Under LOW mode, both fan and LOW heating will be in
function.
•
On status of standby, touch "MODE" continuously for two times, HIGH model will be
set and "High" will flash. M/T,
both fan and HIGH heating will be in function.
•
On status of standby, touch "MODE" continuously for three times, FAN mode will be
set and "Fan" and the fan icon will flash. Under FAN mode, only fan will be in function.
•
If MODE is touched for one MORE time when "Fan" flashes, all functions will be turned off,
and the unit will return to status of standby.
NOTE: When LOW mode or HIGH mode is selected while the heater doesn't work with heat and
fan, that's because the temperature set is lower or equal to the ambient temperature. By touching
"UP" button to set the temperature to a proper point, the heater will work normally.

TEMPERATURE SETTING

•
The presetting temperature is 22 .
•
Touch "UP" or "DOWN" button to set the temperature preferred. Touch "UP" or
"DOWN" once for 1 , and the temperature setting range is from 5
•
About 5 seconds after the temperature is set, the screen will return to show the
ambient temperature.
•
Under LOW or HIGH mode, when ambient temperature reaches the temperature set,
the heating function will be turned off automatically, while the fan will keep on running.
And when ambient temperature is lower than the temperature set, the heating function
will be turned on again automatically.
•
When FAN mode is selected, the temperature setting function will be void.

TIME SETTING

•
Touch TIMER button to set the preferred time for operation. Timer ranges from 1 to 12
hour(s). When the timer is set, countdown will begin after no buttons are pressed for five
seconds. The display will continue to show the remaining time.
•
The heater will shut off automatically when the set time has elapsed, while the fan will keep
on running for 10 seconds for cooling down the heater.
•
Time setting will be erased if standby status is selected by adjusting MODE button or
when the unit is turned off automatically or mechanically.
OSCILLATION SETTING
(with bigger fire icon) will flash. Under HIGH mode,
to 30 .