Care And Maintenance - Hamilton KNAKI X-WIND Manual De Instrucciones

Introduction
Congratulations.
Hamilton is delighted that you have chosen a timepiece
from its collection. You have acquired a small technolog-
ical marvel that will serve you faithfully for many years.
The most advanced technologies were used throughout
its manufacture and it underwent stringent controls
before it was released for sale.
Illustration keys
Hour hand
1
Minute hand
2
Small seconds hand
3
60-second counter
4
30-minute counter
5
12-hour counter
6
Date / Day
7
Exterior rotating bezel
8
Upper interior rotating bezel
9
Lower interior rotating bezel
0
Time / Date / Day setting crown
A
Chronograph start / stop button
B
Chronograph resetting button
C
Crown for adjusting bezel
D
Crown for adjusting bezel
E
2
All manuals and user guides at all-guides.com
9
0

Care and maintenance

Recommendations
• Like all micro-mechanical precision instruments, your
Hamilton watch should be checked at least once
every two years. Entrust your watch to an authorized
Hamilton repair center or to any other professional
watch service.
• To keep your watch water-resistant, make sure that
its sealing features are tested at every check-up.
• Do not move the crown when you are in water.
• Rinse off your watch with fresh water after any
immersion in seawater.
• Dry your watch whenever it gets wet.
• Have your watch checked for water-resistance by an
authorized Hamilton retailer or by any other profes-
sional watch service each time the case is opened.
Water-resistance
The water-resistance of your watch is indicated on the
case back.
Water resistance and equivalent pressure used in Anglo-Saxon countries:
Unit of measure Water resistance categories available
atm (overpressure) 3
psi
44
ft * 100
Water resistance and equivalent pressure used in countries using metric
systems:
Unit of measure Water resistance categories available
bar 3
m * 30
* The values given in feet or meters of immersion in water are equivalent
to the degree of overpressure applied during the tests according to the ISO
22810 standard.
5 10 20 100
72,5 145 290 1450
165 330 660 3300
5 10 20 100
50 100 200 1000
© HAMILTON 19/07/2013