Sauder Barrister Lane 418294 Instrucciones De Montaje página 23

Step 19
Carefully turn your unit over onto its front edges. Unfold the BACK (K) and lay it over your unit.
å
Make equal margins along all four edges of the BACK (K). Push on opposite corners of your unit if needed to make it "square".
å
NOTE: If the 418295 Hutch is attached to your Desk, the BACK (K) will overlap the Hutch Right Back (F) and the corner will tuck
å
underneath the Hutch Left Back (G). Using seven NAILS from the Hutch assembly, fasten the bottom edges of the Hutch Backs
(F and G) to the Desk Top.
Fasten the BACK (K) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up over the UPRIGHT (D) and UPPER SHELF (J).
å
NOTE: Perforations have been provided for access through the BACK. Carefully cut out the holes needed.
å
Slide the LEFT REAR END MOLDING (W) onto the notched edges of the LEFT ENDS (B and C).
å
*U.S. Patent No. 5,499,886
å
These holes must line up over the
UPRIGHT (D) and UPPER SHELF (J).
NAIL
(38 used for the desk BACK)
www.sauder.com/services
If the Hutch has been assembled,
BACK (K) will overlap the Hutch Right
Back (F) and the corner will tuck
underneath the Hutch Left Back (G).
K
1N
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
B
Notched edges
C
418294
Slide the LEFT
REAR END
MOLDING (W) onto
the notched edges.
W
Page 23