Publicidad
Step 2
Separate the EXTENSION SLIDES (Y) from the
å
EXTENSION RAILS (X) as shown in the enlarged diagram
below. Be prepared, the parts are greasy.
Fasten the EXTENSION RAILS (X) to the RIGHT END (A)
å
and UPRIGHT (D). Use four GOLD 5/16" FLAT HEAD
SCREWS (3S).
NOTE: For each EXTENSION RAIL, turn a SCREW into the
å
hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to fi nd the other hole
that lines up with the hole in the END. Turn a SCREW into
this hole.
Push the black lever in and pull the SLIDE from the RAIL.
3S
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
D
Open end
Finished edge
Page 6
Y
X
X
A
418294
Remember:
Righty tighty.
Lefty loosey.
Open end
Notched edge
X
www.sauder.com/services
Publicidad
