Publicidad
Step 21
Carefully stand your unit upright.
å
Before fastening the DOOR to your unit, be sure the
å
mounting screw is against the stops as shown in the right
diagram. If it isn't, loosen the mounting screw to slide it
against the stops. Then tighten the mounting screw.
Fasten the DOOR (L) to the UPRIGHT (D) as shown in
å
the lower diagram. Use the screws in the HINGES. You
should start each SCREW a few turns before completely
tightening any of them.
Fasten a KNOB (69K) to the DOOR (L). Use a BLACK
å
1-1/8" MACHINE SCREW (21S).
See the next step for DOOR adjustments.
å
www.sauder.com/services
D
21S
BLACK 1-1/8" MACHINE SCREW
(1 used in this step)
418294
Pro Tip: Lift with your
legs. And, you know,
your arms.
Stop
Mounting
screw
Hinge
69K
L
Page 25
Publicidad
