decorflame QCM525-47BDC Manual Del Usuario página 11

inches (10 mm) or 1/16 inches (2 mm), Pen-
cil, Hammer, Philips Screwdrivers, Safety
Goggles and gloves (if necessary).
WARNING: Wear goggles when using power
tools.
Option 1: Use the spare KD NUTS, KD-
SCREWS and PLASTIC CONNECTOR
1. Place the PLASTIC CONNECTOR on the
mantel unit and mark the drill-holes as
shown in Fig. B.
2. Drill the holes with diameter 3/4 inches
(10 mm) and depth 3/4 inches (10mm) on
the mantel. Each Plastic Connector needs 3
holes. See Fig. C.
3. Gently install the KD NUTS into the
drilled-holes with hammer as shown in
Fig. D.
M A I N T E N A N C E
4. Attach the PLASTIC CONNECTOR and
lock in place with KD SCREWS as shown in
Fig. E.
Option 2: Use the SMALL L-BRACKETS and
SCREWS
1. Place the SMALL L-BRACKET to the unit
Fig. B
as shown and mark the drill-holes on the
mantel as shown in Fig. F.
Fig. C
2. Drill the holes with diameter 1/16 inches
(2 mm) and depth 5/16 inches (8mm) on the
mantel. Each SMALL L-BRACKET needs 4
holes. See Fig. G.
11
Fig. D
Fig. E
Fig. F