decorflame QCM525-47BDC Manual Del Usuario página 9

outlet. If the cord does not reach, you may
use an extension cord rated for a minimum
of 1875 WATTS. Once the fireplace insert
has been properly connected to a grounded
electrical outlet, it is ready to operate.
OPERATION BY
THE CONTROL PANEL
The controls are located behind the grill
below the front glass and can be accessed
by pulling the grill from the top, forward
and down.
May not be as exactly as shown
ON/OFF: Press this button for main power
and flame effect. The indicator light will turn
O P E R A T I O N
on. See below for other control switches.
750W: For low heat function - Press this
switch while the ON/OFF switch is in the on
position for low heat. The indicator light will
turn on.
1500W: For high heat function - Press this
switch while the ON/OFF switch and the
750W switch are in the on position for high
heat. The indicator light will turn on.
Temperature Control: To adjust the tem-
perature to your individual requirements,
turn the temperature control dial to the
right (clockwise) to increase the desired
temperature and to the left for lower
temperature. This temperature control dial
can only be used while the ON/OFF switch
and 750W & 1500W switches are in the
ON position. When the heater reaches to
the desired temperature, the heater and
750W/1500W indicator light will off but the
fan still keeps working with air flow. Adjust
this knob to restart the heater.
Dimmer Control Knob: Turn the dimmer
dial clockwise or counter clockwise to get
the desired flame intensity. The dimmer
switch can only be used when the ON/OFF
switch is in the on position.
Note: When the ON/OFF switch is turned
off, all other heater functions will stop even
though the switches may be in the
on position.
NOTE: In order to shut down the heater
safely, it is recommended to turn the Tem-
perature Control knob to lowest setting and
allow the heater to cool down before press
the ON/OFF switch to off position.
9