decorflame QCM525-47BDC Manual Del Usuario página 8

A S S E M B LY I N S T R U C T I O N S
Step 2: Attach 3 SMALL BRACKETS [N] on
the top of insert and lock in place with 3
SHORT KD SCREWS [O]. See Fig. 11.
Step 3: Attach 4 MED BRACKETS [P] to
the bottom of insert with 4 MEDIUM KD
SCREWS [Q] as shown in Fig. 12
Step 4: Tighten all SCREWS.
CAUTION: The Electric Fireplace Heater
should not be positioned in an area that is
exposed to direct sunlight.
WALL ANCHOR
SAFETY CABLE
The use of WALL ANCHOR SAFETY CABLE
is highly recommended in order to reduce
the risk of the fireplace being tipped over
accidentally. WARNING: This CABLE may
reduce possible risk of injury if the fireplace
is improperly handled, but is not a substitute
for proper adult supervision. Children should
not be left unattended near any heater.
Fig. 11 1. Drill a 5/16" (8mm) hole in the wall. Insert
the PLASTIC WALL ANCHOR into the hole
and gently tap until the flange on the anchor
is against the wall surface.
2. Position the back edge of the mantle close
to the wall.
3. Attach the SAFETY CABLE to the mantle
using the SCREW FOR MANTLE. See fig. 13
4. Use the SCREW FOR WALL to attach the
other end of SAFETY CABLE to the wall.
5. Make sure all screws are tight.
Fig. 12
After reading complete instructions, confirm
all controls on fireplace are in the OFF posi-
tion. Plug the fireplace into a 15AMP/120Volt
8
Fig. 13