Mounting Requirements; Mounting The Device - SICK PowerProx Mini Instrucciones De Uso

4
MOUNTING
4.2

Mounting requirements

4.3

Mounting the device

10
• Typical space requirement for the device, see type-specific dimensional drawing,
see „Dimensional drawings", page
Comply with technical data, such as the permitted ambient conditions for opera‐
•
tion of the device
Figure 2: Sensor alignment
Figure 3: Standard direction
1. Mount the sensor using a suitable mounting bracket (see the SICK range of acces‐
sories).
2. Note the sensor's maximum permissible tightening torque of 0.8 Nm.
3. Align the sensor with the object. Select the position so that the red emitted light
beam hits the center of the object. You must ensure that the optical opening (front
screen) of the sensor is completely clear.
4. Note the preferred direction of the object relative to the sensor.
page 10
19.
see figure 2, page 10
see figure 3,
8022570 | SICK
Subject to change without notice