Intended Use; Improper Use; Limitation Of Liability - SICK PowerProx Mini Instrucciones De Uso

2.2

Intended use

2.3

Improper use

2.4

Limitation of liability

8022570 | SICK
Subject to change without notice
CLASS 1 LASER PRODUCT
Laser
1
EN / IEC 60825-1:2014
IEC60825-1:2007
Maximum pulse power < 500 mW
Puls length: ≤ 2 ns
Wavelength: 650 - 670 nm
Complies with 21 CFR 1040.10
and 1040.11 except for deviations
pursuant to Laser Notice No. 50,
dated June 24, 2007
ATTENTION
WARNING: Interruption, manipulation or incorrect use can lead to hazardous exposure
due to laser radiation.
The WTT4SLC is an opto-electronic photoelectric proximity sensor (referred to as "sen‐
sor" in the following) for the optical, non-contact detection of objects.
The system designer must provide measures to ensure the safety of persons and sys‐
tems in accordance with the legal guidelines.
SICK AG assumes no liability for losses or damage arising from the use of the product,
either directly or indirectly. This applies in particular to use of the product that does not
conform to its intended purpose and is not described in this documentation.
• The device does not constitute a safety-relevant device according to the EC
Machinery Directive (2006/42/EC).
• The device must not be used in explosion-hazardous areas.
Any other use that is not described as intended use is prohibited.
•
Any use of accessories not specifically approved by SICK AG is at your own risk.
•
The device is not suitable for the following applications (this list is not exhaustive):
As a safety device to protect persons, their hands, or other body parts
•
• Underwater
In explosion-hazardous areas
•
• Outdoors, without additional protection
NOTICE
Danger due to improper use!
Any improper use can result in dangerous situations.
Therefore, observe the following information:
The device should be used only in line with intended use specifications.
b
All information in these operating instructions must be strictly complied with.
b
Applicable standards and regulations, the latest technological developments, and our
many years of knowledge and experience have all been taken into account when
assembling the data and information contained in these operating instructions. The
manufacturer accepts no liability for damage caused by:
SAFETY INFORMATION
2
7