Horizon Global CQT76521 Instrucciones De Instalación página 5

4. Remove taillight cover – Using plastic trim tools remove the plastic
taillight cover from the driver side. Using T20 torxbit remove (1) screw
below the cover that was removed. Repeat these steps for passenger side.
6. Install hitch – Use 15 mm socket to remove (6) M8 bolts from bumper beam. NOTE: Do not complete remove bumper beam. Starting with the driver side, raise
the hitch into position, on top of impact bar structure, and loosely tighten M8 bolts provided in fastener kit. Tighten all fasteners with torque wrench to 20 Lb.-Ft.
(27 N*M). See Figure 1.
Impact bar
①
①
①
Figure 1
©2021 Horizon Global™ Corp - Printed in Mexico
5. Fascia removal - Using T20 torxbit remove (2) screws from center of fascia.
Use plastic trim tools to remove the fascia starting at the outer edges near the
wheel wells and gently pull the fascia. Disconnect wiring harness on passenger
side if present. Carefully set the fascia aside for reinstallation.
Bumper
end panel
Sheet 5 of 18 76521NP 7-14-21 Rev. A