Service/Maintenance; Filter Replacement - Dustcontrol DC 1800 Traducción Del Manual De Instrucciones De Servicio Original

Emptying
• The container underneath the cyclone should be emptied when about 2/3 full.
• You can use the machine with or without a plastic bag in the container.
• You must clean the filters before replacing the plastic bag.
• The plastic bag must be sealed as soon as it is removed from the container.
• Only use original bags as there must be no creases around the edge of the
container. This tight seal prevents the bag from being suctioned up.
For best results:
• When attaching the plastic bag, ensure that there is no air between the plastic bag
and the container.
• Ensure that air does not enter between the container and the bag when the machine
is running.

Service/Maintenance

Cleaning
The machine must be switched off and unplugged before cleaning and maintenance.

Filter replacement

The fine filter must be replaced at least once a year. Only OEM filters may be used.
HEPA filters must be replaced after 300 hours.
Filter replacement may only be performed by trained personnel. Use a protective
mask and suitable equipment.
Release and lift off the upper part for free access to the filter. Lift the filter straight up.
If appropriate, fit a plastic bag over the cyclone to prevent the dust in the filter from
spreading. Check the gasket when replacing the filter. A worn gasket can allow
hazardous dust to escape. Never use old gaskets or non-OEM parts. Place used
filters in a plastic bag and seal the bag. See instructions below.
1
Motor
The typical service life of a fan motor's original brushes is 600-700 hours. The brush
can be replaced. The service life of the second brush set is approx. 400 hours, while
All manuals and user guides at all-guides.com
2
DC 1800, Art.nr. 94114-J
3 4
27