Reer S-Gate Manual Del Usuario página 11

Installation on stairs
Especially well suited for installation at the top of stairs as it opens completely and does not
present a tripping hazard. Here, the direction of opening
shall be limited by the installation of the supplied
stopper (n) (Step 5)
(A) Install at the top of the upper the stair
and do not install on one of the stairs.
(B) If the safety barrier is used at the bottom of
the stairs, it should be positioned in the front
of the lowest tread possible.
ATTENTION: The gate must always open in the direction away from the hazard zone to
Installation
Step 1
Attach the parts (a) and (b) of the safety gate as depicted in fig. 1 and 2. Then push them in the
direction of each sides opening until the distance between the outer vertical gate slats and the
surface it is mounted to is at least 30 mm and maximum 62 mm, fig. 3.
Step 2
Attach respectively two mounting screw sets (i) and (j) to the upper and lower part of the door,
fig. 4 and 5. Check if the door parts (a) and (b) are tightly attached to each other and the vertical
slats are flush. Screw tight with a Phillips screwdriver.
Step 3
Attach hinge bolts with nuts (d) on the side opposite of the closure of the gate (b) at the top and
the bottom, fig. 7 and 8.
Attach the adjustment screw (c) on the other side of the gate (a) at the bottom, fig. 6.
Step 4
Mark the drill holes on the hinge side (b) with the help of the mounting template (l). These are
marked with the name "hinge", fig. 10, 11 and 12. First, only the lower hinge parts (h) are
Installing the
hinge side fastened using the wood screws (k), fig. 13 and 14.
Use suitable screws and plugs for other mounting surfaces. 1)
Step 5
The screw holes for the closing side (a) must be marked using the mounting template (l). These
Installing the are marked with the name "latch", fig. 16.
locking side
Optionally, the stopper can be inserted either on the left or on the right. For this purpose, insert
installing the
stopper the stopper (n) on the side in the hinge support (m), fig. 9, before it is fastened using the wood
screws (k), fig. 15 and 17.
Step 6
Insert the hinge bolts (d) that are on the gate into the two lower hinge parts (h). Only mount the
upper hinge parts (g), fig. 18 and 19.
avoid dangerous situations. The amount the safety gate is opened can be
limited by installing the stopper (n), which comes with the gate. (Step 5)
- 9 -
(A)
(B)
1) not included in scope of delivery