Starting + Stopping - sunjoe HJ605CC Manual Del Operador

1. Pull the angle unlock button backward and hold it in
position (Fig. 22).
Fig. 22
2. Turn the cutting head slightly clockwise or
counterclockwise (Fig. 23).
Fig. 23
3. When the cutting head clips in the desired angle, release
the angle lock button.
m
WARNING!
Always ensure the cutting head is in one of
the five positions. Never adjust it into an intermediate position.
m
WARNING!
Always ensure the angle unlock button
snaps back into place after adjusting the angle. Leaving the
pole head unlocked during operation is dangerous (Fig. 24).
Fig. 24
The telescoping pole's cutting head can also be set to 7
vertical angles: -90°, -67.5°, -45°, -22.5°, 0°, 22.5°, 45°
(Fig. 25). Follow the instructions to adjust the angle.
Angle unlock button
Fig. 25
45°
22.5°
0°
-22.5°
4. Rotate the cutting head to the desired cutting angle while
pressing the angle adjustment button (Fig. 26).
Fig. 26
5. Release the button when the cutting head is fixed into the
desired angle.

Starting + Stopping

1. To power ON, push and hold the safety lock-off button
with your thumb, while pressing the ON/OFF trigger
switch with your forefinger. Once the trigger switch
engages, you can release the safety lock-off button and
proceed with operation (Fig. 27).
12
-90°
-67.5°
-45°
Angle adjustment
button