sunjoe HJ605CC Manual Del Operador página 8

2. Gently remove the blade by lifting the end tip of the blade
off of the grass shear + hedge trimmer unit (Fig. 4).
Fig. 4
3. Insert the desired blade into the base of the motor housing
(Fig. 5).
Fig. 5
NOTE: You may need to manually move the blade or gear
shaft in order to align the gear shaft with the gear in the center
of the unit.
4. Align the gear shaft in the middle of the blade with the
gear in the middle of the unit. Align four lugs so that the
blade lays flat against the housing for a secure fit (Fig. 6).
Fig. 6
Lugs
Lugs
5. Once the blade is in position, replace the blade cover by
Fig. 7
NOTE: If you have any questions, please call the Snow Joe
+ Sun Joe
(1-866-766-9563) for assistance.
Telescoping Pole Assembly (Optional)
1. Unlock the telescoping lock by flipping it up (open), and
Fig. 8
Upper pole
Fig. 9
Gear shaft
8
aligning the cover with the slots on the base of the motor
housing and push forward on the blade cover until it slides
and clicks into place (Fig. 7).
customer service department at 1-866-SNOWJOE
®
insert the lower pole into the upper pole. Make sure the
groove in the end of the lower pole is facing the opposite
direction of the telescoping lock. Keep the power cord
inside of the pole tubes (Figs. 8 – 9).
Upper pole
Telescoping lock
Lower pole
Groove
Telescoping lock
Power cord
Lower pole
®