Installation; Installation Instructions; Preparing Location; Mounting The Duct Cover Bracket - Dacor DHD30M700WS Instrucciones Para Instalación

Installation

Installation Instructions

We recommend that a qualified technician install the range hood. It is the installer's responsibility to ensure the
range hood complies with the installation clearances specified for the product.

Preparing Location

• We recommend you install the vent system before you install the hood.
• Before making cutouts, make sure there is proper clearance within the ceiling or wall for the exhaust vent.
• Check your ceiling height and the hood height maximum before you select your hood.
1. Disconnect power.
2. Determine which venting method to use: roof or wall.
3. Select a flat surface for assembling the range hood. Place a covering over that surface.
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:
4. Using 2 or more people, lift the range hood onto covered surface.

Mounting the Duct Cover Bracket

1. Determine and mark the centerline on the wall where the canopy hood will be installed. Shut off power at
the circuit breaker panel or fuse box.
2. Select a mounting height of no less than 24" (61 cm) above an electric cooking surface or 27" (68.6 cm) abo-
ve a gas cooking surface.
3. Tape the template in place, aligning the template center line and bottom with the hood center line and
hood bottom line marked on the wall.
4. Mark the centers of the fastener locations on the wall by pushing a pencil point through the template.
IMPORTANT: All screws must be installed into the wood studs or framing. If there is no wood to screw into,
additional wall framing supports may be required.
5. Drill ⁄ " (4.8 mm) pilot holes at all locations where screws are going to be installed into wood.
3
16
A
C
B
A. Centerline
B. Fastener Locations
C. Mounting Height Reference (Hood Bottom Line)
ENGLISH 11