Installation
Install the Range Hood
WARNING
USE TWO OR MORE PEOPLE TO MOVE AND INSTALL THE RANGE HOOD. FAILURE TO DO SO CAN RESULT IN
BACK OR OTHER INJURY.
1.
Mark the lower mounting hole locations with a pencil .
2. Uninstall the hood assembly, and drill ³⁄₁₆" (4.8 mm) pilot holes at the marked locations.
3. Hang the range hood on 2 the upper mounting screws.
4. Level the range hood and tighten the upper mounting screws.
5. Install 2 - 5 x 45 mm lower mounting screws and tighten. Use the optional wall anchors if needed.
Connect the Vent System
1.
Install the transition on top of the hood (if removed for shipping) with 2 - 3.5 x 9.5 mm sheet metal screws.
2. Fit the vent system over the exhaust outlet.
B
C
A. Mounting Screws
B. Mounting Slots
C. Lower Mounting Screws
A
A. Vent Transition
B. 3.5 x 9.5 mm Screw
A
B
ENGLISH
13