Changing Parameters - Dometic AH-Elite Control Manual Del Usuario

AH-Elite Control
✓ The display alternates between "P-1" and "95" (or a different number between
"35" and "95").
➤ Press button
✓ The software version (e. g. "B23") is displayed for 1 second before the system
changes back to off mode.
9.3

Changing parameters

➤ Make sure the system is in program mode. (In program mode the parameter num-
ber (e. g. P-1) and the parameter setting are displayed alternately.)
➤ Use button
to increase the parameter number or use button
the parameter number until you reach the parameter you want to change.
➤ Use buttons
➤ Repeat these steps until all parameters have the desired settings.
✓ The parameter settings have been changed. You can now proceed by exiting
program mode (chapter "Exiting program mode" on page 18) or by saving the
settings as new default settings (chapter "Handling default settings" on page 19).
9.4 Handling default settings
The system is delivered with the factory default settings listed in the table (chapter
"Parameter overview" on page 21).
You can adapt these settings to your system configuration and set custom default
values. Note the custom default settings in the column "Custom".
Memorizing new program parameters
➤ Make sure the system is in program mode. (In program mode a parameter
number (e. g. P-1) and the parameter settings are displayed alternately.)
➤ Make all the changes you want to save as new default settings.
➤ Simultaneously press buttons
✓ The current parameter settings are memorized as new default settings. The
system exits program mode.
EN
.
and to change the parameter setting.
and
Programming the control unit
.
to decrease
19