Programming The Control Unit - Dometic AH-Elite Control Manual Del Usuario

Programming the control unit

8.6 Changing the set point temperature
➤ Press button
➤ While the set point temperature is displayed press and hold button
to increase or decrease the set point temperature.
➤ To make finer adjustments press button
or decrease the set point temperature by 1 °F (0,55 °C) every time the button is
pressed.
✓ The new set point temperature is shown for 5 seconds before the display
changes back to the inside air temperature.
9 Programming the control unit
9.1 Entering and exiting program mode
Entering program mode
➤ Make sure the system is in off mode.
➤ Press button
➤ Press button
➤ Press button
➤ Press button
✓ The display alternates between "P-1" and "95" (or a different number between
"35" and "95"). This means the system is in program mode and the first parame-
ter (P-1) can be changed.
Exiting program mode
If no button is pressed for 50 seconds, the system will exit program mode automati-
cally. Press button
9.2 Identifying the software version
Some software functions and programmable parameters are only available for spe-
cific software versions. You should therefore identify the software version of your
control unit before starting to program it.
➤ Enter program mode.
18
or button once to display the set point temperature.
.
.
.
.
to change back to off mode without waiting for 50 seconds.
or button repeatedly to increase
AH-Elite Control
or button
EN