Operating The System - Dometic AH-Elite Control Manual Del Usuario

Operating the system

• Away from any heat-producing appliances
• Outside of bulkheads
• Outside of the supply-air stream
• Not above or below ventilation grilles
• Within reach of the display cable
If you can not mount the display in a suitable location for accurately sensing room
temperature, install the optional remote air sensor.
7.2 Mounting the display
I
NOTE
The display cable needed to connect the display to the control unit is not
included in the scope of delivery. Please obtain a display cable prior to
mounting the display.
➤ Prepare the cut-out for the display according to the mounting dimensions shown
(fig. 2, page 3 for Elite Idea or fig. 3, page 4 for Elite Eikon).
➤ Prepare the drill holes as shown (fig. 4, page 4 and fig. 5, page 5).
➤ Connect the display as shown (fig. 6, page 5 for current AH-boards or fig. 7,
page 6 for legacy I/O-boards).
➤ Mount the display as shown (fig. 8, page 6).
➤ Mount the bezel over the display frame until it snaps into place.
8 Operating the system
I
NOTE
If your air conditioning unit has a Shaded-Pole (SP) fan motor instead of a
Split-Capacitor (SC) High-Velocity (HV) fan motor, you must program
"SP" into parameter P-14 before operating the equipment. Refer to
chapter "Programming the control unit" on page 18 to find out how to
change the parameter setting.
12
AH-Elite Control
EN