Installation Instructions - Brunner CLS-E YOKE Guia De Inicio Rapido

2 INSTALLATION INSTRUCTIONS

GENERAL
Open the box carefully and remove all packaging.
The following material is included:
1. CLS-E Yoke
2. USB Cable
3. Power supply with cable
4. This manual
MOUNTING & OPERATING CONDITION
1. The unit must be mounted with 4 Screws
on a flat surface before operating.
2. Keep a minimum of 5 cm distance around
the unit from any part.
3. Keep environmental temperature below 40°C max.
4. Use only in dry environment.
FIRST START / ELECTRICAL CONNECTION
1. Connect the CLS-E Yoke with your computer via the
provided USB cable. See Chapter 5 Wiring Diagram on page 28.
2. Connect the power supply cable to the yoke.
3. The calibration and initialization sequence will start as
soon the "INIT" -Button on the display is clicked or CLS2Sim
software is running (if Auto-Init feature is enabled).
Axis are moving across their range.
DO NOT DISTURB THIS SEQUENZ UNTIL THE YOKE IS
CENTERED! THIS SEQUENCE IS REPEATED EVERY TIME
WHEN POWER IS APPLIED.
4