Nemaxx FL10-VdS Manual Del Usuario página 10

INSTALLATION
CAUTION
MUST activate alarm first, or else there is no function for this unit.
Activation
Press test button and hold it for above 3 seconds until LED lights, and release it
within 2 seconds, the unit will generate a "beep" indicates that it is activated and
goes into work status
• Turn the alarm body counterclockwise and take off the bracket.
• Press the bracket on the installation position, mark installation hole of the bracket with
pencil.
• Bore two installation holes on the sign with electric drill. Make diameter of holes is 5mm,
Strike the two plastic plugs into holes with hammer.
• Remove fixing plug from the bracket with screwdriver if necessary (Refer to Diagram 4).
• Attach the bracket to the plastic plugs and fix tightly the screws into the plastic plugs.
(Refer to Diagram 5).
• Fit the alarm on the bracket and turn the alarm body clockwise, until matching well on
the bracket.
• Insert fixing plug to the gap between bracket and bottom cover for fixing alarm if you
want(Refer to Diagram 6).
• Press the button for test the unit. The alarm sounds 3 beeps – 1.5 seconds pause,
repeat it until release the button, if no sound, it indicates a defective alarm,
you can refer to "Trouble shooting" for solution or return to your retailer during warranty.
• If you have any questions on installation, you can contact your retailer.
WARNING
To prevent injury, this unit must be securely attached to the wall or ceiling in
accordance with the installation instructions.
EN
10
Version: 2.0
14.07.2016