Nemaxx FL10-VdS Manual Del Usuario página 7

TROUBLE SHOOTING
Problem
Smoke alarm device does not
sound when tested.
The alarm "chirp" with red LED
flashes once every 40 seconds.
Smoke alarm device chirp occurs
every 40 seconds (alarm goes
into fault mode).
Smoke alarm device sounds
unwanted alarms intermittently
or when residents are cooking,
taking showers, etc
The alarm sounds different from
it is used to.
It starts and stops.
EN
Method of disposal
1. Must activate alarm before installation
2. Clean smoke alarm device.
Please refer to the "maintenance and cleaning"
section.
3. if there are still failures during warranty, you can
return to your retailer.
4. if the unit is out of warranty, please replace
another new alarm.
The battery is under low battery status, please
replace the smoke alarm device.
Clean smoke alarm device.
Please refer to the "maintenance and cleaning"
section. Purchase and change another smoke alarm
device if the problem still exist
1. Press test button to pause alarm.
2. Clean smoke alarm device.
Please refer to the "maintenance and cleaning"
section.
3. Move smoke alarm device to new location and
press test button.
1. Clean smoke alarm device. Please refer to the
"maintenance and cleaning" section.
2. if there are still failures during warranty, you can
return to your retailer.
3. if the unit is out of warranty, please replace
another new alarm.
7
Version: 2.0
14.07.2016