Installing Line In Reeleasy™ String Head - Ryobi RBC430SESD Manual De Utilización

bump knob, to turn the hex bolt counterclockwise and
tighten securely.
NOTE: Only use the knob to tighten the bolt. The use of
other tools may allow over tightening of the bolt, which
could damage the line trimmer head.
■ Install the spring into the string head housing and push
down to seat.
■ Installing the spool. The spool should be placed so
"this side out for straight shaft" is visible.
■ Replace the bump knob in the spool.
■ Replace the string head cover, aligning latches with
openings in the string head. Press string head cover
and string head housing together until both latches
snap into openings securely.
INSTALLING LINE IN REELEASY™ STRING HEAD
See fi gure 15b.
■ Use a 2.4 mm diameter monofilament string.
■ Stop the engine.
■ Cut one piece of string approximately 6 m in length.
■ Rotate the knob on the string head until the line on
knob aligns with the arrows on the top of string head.
■ Insert one end of the string into the eyelet located on
the side of the string head and push until string comes
out through eyelet on the other side.
■ Continue to push string through the string head until
the middle section of the string is inside the string head
and string outside the string head is evenly divided on
each side.
■ Rotate the knob on the line trimmer head to wind the
line.
■ Wind the string until approximately 20 cm remains
protruding from the string head.
CLEANING AIR FILTER SCREEN
See fi gure 13.
■ For proper performance and long life, keep air filter
screen clean.
■ Remove the air filter cover by pushing down on the
latch with your thumb while gently pulling on the cover.
■ Remove the air filter.
■ Rinse, and let the air filter dry completely.
NOTE: If damaged, replace immediately.
■ Reinstall the foam filter.
■ Reinstall the air filter.
■ Replace the air filter cover by inserting the tabs on the
bottom of the cover into the slots on the air filter base;
push the cover up until it latches securely in place.
All manuals and user guides at all-guides.com
English (Original instructions)
FUEL CAP
A leaking fuel cap is a fi re hazard and must be replaced
immediately.
The fuel cap contains a non-serviceable fi lter and a
check valve. A clogged fuel fi lter will cause poor engine
performance. If performance improves when the fuel cap
is loosened, check valve may be faulty or fi lter clogged.
Replace fuel cap if required.
SPARK PLUG REPLACEMENT
See fi gure 17.
This engine uses a Champion RY4C or NGK CMR7A
spark plug with 0.6mm electrode gap. Use an exact
replacement and replace annually.
Be careful not to cross-thread the spark plug. Cross-
threading will seriously damage the engine.
26
WARNING
CAUTION