LEXIBOOK PC300ACRE Guia Del Usuario página 2

CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER
(OR BACK). NO USER-SERVICEABLE PARTS INSIDE, REFER SERVICING TO QUALI-
RISK OF ELECTRIC SHOCK
DO NOT OPEN
FIED SERVICE PERSONNEL.
The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to
the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient
magnitude to constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended to alert the user to presence of important
operating and maintenance (servicing) instructions in the literature accompanying the appliance.
The symbol for Class II (Double Insulation)
WARNING
To prevent fire or shock hazard, do not expose this appliance to rain or moisture.
The apparatus should not be exposed to dripping or splashing and no objects filled with liquids, such as
vases, shall be placed on the apparatus.
The ventilation should not be impeded by covering the ventilation openings with items, such as
newspapers, table-cloths, curtains, etc.
No naked flame sources, such as lighted candles, should be placed on the apparatus.
The mains plug is used as the disconnect device, the disconnect device should remain readily operable.
In order to disconnect he apparatus from the mains completely, the mains plug should be disconnected
from the mains socket outlet completely.
FOR UK ONLY
For your own safety read following instructions carefully before attempting to connect this alarm
clock radio to the mains.
Mains Supply 220V - 240V~ 50Hz - AC only
This unit is designed to operate on a 220V-240V~ 50Hz supply only. Connecting it to other power
sources may damage it. Ensure that the supply corresponds to the information on the rating label on
the rear panel of the unit.
This component system may be fitted with a non-rewireable plug. If it is necessary to change the
fuse in a non-rewireable plug the fuse over must be refitted. If the fuse cover becomes lost or
damaged, the plug must not be used until a replacement, available from the manufacturer, is
obtained. It is important that the colour of the replacement fuse cover corresponds with the colour
marking on the base of the plug.
If the plug needs to be changed because it is not suitable for your socket, or becomes damaged, it
should be cut off and an appropriate plug fitted following the wiring instructions below. The plug
must then be disposed of safely, as insertion into a 13A socket is likely to cause an electrical hazard.
IMPORTANT
The wires in the mains plug should be connected as shown in the diagram.
The colours of the wires in the mains lead of the unit may not correspond with the coloured markings
identifying the terminals in your plug. Connect them as follows:-
The wire which is coloured blue must be connected to the
terminal which is marked with the letter 'N' or coloured
black.
The wire which is coloured brown must be connected to the
terminal which is marked with the letter 'L' or coloured red.
There should be no connectin to the earth terminal of your
plug.
If a 13 Amp (BS1363) Plug is used, a 3 Amp Fuse must be
fitted, or if any other type of Plug is used a 3 Amp or 5 Amp
Fuse must be fitted, either in the Plug or Adaptor, or on the
Distribution Board.
All manuals and user guides at all-guides.com
GB - 1
BLUE
(NEUTRAL)
OUTER
SLEEVE
CORD GRIP
FUSE
BROWN
(LIVE)