DeWalt DWX726 Manual De Instrucciones página 8

All manuals and user guides at all-guides.com
ATTACHING THE EXTENSION WORK SUPPORTS (FIG. 9, 10)
IMPORTANT: Be sure the longer side of the "T" in the work support
arm (B) is oriented down as shown in Figure 9. Ensure the arrow on
the label points down.
1. Insert the work support arm with the small black cap (B, Fig. 10
inset) into the hole (NN) of the stand closest to the red activating
lever. Push the arm in to lock in place.
2. Repeat for other work support arm on opposite end. Push the arm
in to lock in place.
3. With the stand raised to desired height, place the top piece (H1)
of the extension work support into the top of the work support
arm (B) hole. Insert the bottom piece (H2) of the
support into the bottom hole of the
orientation to the top piece, refer to figure 9.
4. Tighten the vertical lock knob (F).
5. Repeat with the other extension work support.
NOTE: The internal locking mechanism keeps the work supports from
disengaging.
FIG. 9 FIG. 10
H
H1
B
B
F
H2
ATTACHING THE CORD WRAPS (FIG. 11, 12)
NOTE: Place the cord wraps (X) in opposite positions to hold the cord
securely.
1. Place the cord wrap screw (X) into the hole (LL) from outside of
stand. Place the washer (JJ) and nut (KK) on cord wrap screw and
finger tighten nut.
2. Using a crescent wrench or 1/2 inch open end wrench, tighten the
screw securely.
3. Repeat for the other cord wrap.
FIG. 11
extension work
work support arm, with proper
NN
ATTACHING THE TOOL (FIG. 13–16)
WARNING: STABILITY HAZARD. Refer to your tool manufacturer's
instructions regarding the securing of your miter saw or planer to a
stand or supporting surface. Secure the tool according to both the
instructions in this manual and those in your tool manufacturer's
manual before operating. Failure to heed these warnings may result in
serious personal injury and serious damage to the tool.
6
FIG. 12
LL
JJ
X
X
KK