Sauder 414836 Manual De Instrucciones página 11

Step 6
Separate the EXTENSION SLIDES (AA) from the EXTENSION RAILS (Z) as shown in the upper diagram below. Be
å
prepared, the parts are greasy.
Fasten an EXTENSION RAIL (Z) to the LEFT END (C) and UPRIGHT (D). Use four GOLD 5/16" FLAT HEAD SCREWS (3S).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
å
cartridge of the EXTENSION RAIL in to fi nd the other hole that lines up with the hole in the END and UPRIGHT. Turn a
SCREW into this hole.
Slide the LEFT MOLDINGS* (R) onto the notched edges of the LEFT END (C) and UPRIGHT (D).
å
*U.S. Patent No. 5,499,886
å
The MOLDING (R) should
be even with this edge.
C
Open end
Notched edge
www.sauder.com/services
AA
Push the black lever in and pull the SLIDE from the RAIL.
The MOLDING (R) should
be even with this edge.
D
Z
R
Notched edge
Z
414836
Z
3S
GOLD 5/16" FLAT HEAD SCREW
(4 used for the RAILS)
Open end
R
Page 11