Publicidad
Step 15
Fasten two CARD HOLDERS (35M) to the LOWER SHELF
å
MOLDING (W). Use four SILVER 1/2" MACHINE SCREWS (38S).
Fasten two METAL BRACKETS (4G) to the LOWER SHELF (I). Use
å
two BLACK 9/16" LARGE HEAD SCREWS (1S).
NOTE: Be sure the BRACKETS are even with the edge of the
å
LOWER SHELF.
Fasten the LOWER SHELF MOLDING (W) to the LOWER
å
SHELF (I). Use two BLACK 9/16" LARGE HEAD SCREWS (1S)
through the METAL BRACKETS and into the holes in the LOWER
SHELF MOLDING.
BLACK 9/16" LARGE HEAD SCREW
(4 used for the METAL BRACKETS)
Page 20
W
1S
These surfaces
should be even.
This hole
must be here.
35M
4G
I
H
414836
SILVER 1/2" MACHINE SCREW
(4 used for the CARD HOLDERS)
W
Open end
Do not apply any
pressure to the
SHELVES (H and I).
www.sauder.com/services
38S
Publicidad
