Attaching The Toys; Assembling The Art Table - Stage 2 - Evenflo exersaucer BABY ACTIVE Manual Del Usuario

Attaching the Toys

WARNING
Toys with cap MUST be in place
when Stage 1 is in use.
J > @
J > !
A > !
J > %
To remove batteries from mirror toy,
remove two screws , and lift mirror face.
J > %
To replace mirror face, replace screws.
DO NOT OVERTIGHTEN.
All manuals and user guides at all-guides.com
To place toy with cap on ExerSaucer, set
toy cap J > ! on top of Leg, as shown. Push
down until tab J > @ rests in dimple
Leg to ensure toy is attached properly.
To remove toy from ExerSaucer, grab cap
and pull straight up.
J > #
J > $
WARNING
Secure Spin-Loc™ toys every time the
ExerSaucer is used.
To secure Spin-Loc toys on ExerSaucer
Tray, set toys on Tray and twist toy base
clockwise as shown. Pull up on toys to make
sure they are locked in place.
To remove Spin-Loc toys from Tray, twist toy
base counterclockwise, squeeze tabs
lift, as shown.
If Spin-Loc toy does not stay attached, clean
suction cup per cleaning instructions for
plastic parts on page 9.
Batteries
Refer to battery door
for quantity and size
of batteries.
Remove screw from battery door.
Replace screw after batteries have
J > ^
been replaced. DO NOT OVERTIGHTEN.
6
STAGE 2
A > ! on
Stage 2 Art Table MUST be in highest position at all times.
H
,
J > #
and
J > $
J > ^
WARNING
Stage 2 is for use by children who can walk unassisted
up to approximately 48 months.
Note: Remove all toys from ExerSaucer
before assembling the Art Table.
H
1. Remove Base
ExerSaucer.
2. Turn ExerSaucer upside down.
3. Remove Bounce Ring
D > !
Push tab
Repeat until all six tabs are released
D > @
from Tray.
7
Assembling the Art Table
STAGE 2
from bottom of
H
from Tray.
D > !
until it releases from Tray.
D > @