Technoline WS 6812 Manual Del Usuario página 9

Your weather station will receive data signal from the outdoor sensor in few seconds. Then place
your outdoor sensor in a dry and shaded area outdoor.
4) Peel off the protective label on the front. Your weather station is ready to work for you.
Remarks:
1. Keep in mind that your outdoor sensor has a 100 feet open-air transmission with no obstructions.
Actual transmission range will vary depending on what is in the path of the signal. Each obstruction
(roof, walls, floors, ceilings, thick trees, etc.) will effectively cut signal range in half.
Insert the holder to the bottom of the outdoor transmitter for desktop or insert it to the back of the
transmitter for wall mount purpose.
Battery Back Up
When the power supply is not in use, the station will be powered by the back-up batteries. The LED
display is turned off, but time and alarm time remain stored (also in the event of a power failure).
DCF SIGNAL RECEPTION AND SIGNAL INDICATOR
After your clock is powered up, it starts to receive DCF signal. The
Receiving DCF signal
Successful Reception
Failed Reception
During reception, press
Indication:-
When strong DCF signal is detected, display shows with 3 bars
When weak or no DCF signal is detected, display shows
During reception, the signal strength may move from 1 bar to 2 bars to 3 bars. This is normal since
the clock is detecting DCF signal and other signals in the air at the same time. Press SET will return
to the time display with
Successful reception or failed reception
icon becomes static (stop blinking) when reception is successful
icon disappears when reception is failed
Automatic reception and Manual Reception
Your clock starts automatic reception everyday at 1:00, 2:00, and 3:00. If it fails to receive the DCF
( icon flashing)
( icon becomes static)
( icon disappear)
/ WAVE once will display reception mode and signal strength
icon flashing.
icon flashes.
or
GB 3