universalblue UCEF90101-20 Manual De Instrucciones página 23

• This appliance must be installed in accordance with
current regulations.
• Do not block any ventilation holes.
• Do not move the device when it is in operation.
• Close the gas valve before moving the appliance.
• The regulator hose should be checked frequently (at
least once a month and every time the gas cylinder
is replaced). If it shows signs of deterioration it
should be replaced with a hose with same length
and similar quality.
• Gas regulator hose must be changed regularly at the
intervals prescribed by the manufacturer.
• Use only the type of gas indicated by the
manufacturer.
• In case of high or extreme wind, it is recommended
not to use the device as it could tip over and cause
damage or fire.
• Injector installed in this device is not designed for
extraction.
• Do not connect the gas cylinder directly to the
appliance without a regulator.
• The hose used must comply with EN16436: 2014
and gas regulator must comply with EN16129:
2013. Regulator must be regularly replaced based
on national regulations.
Use the regulator for butane/propane from any of
•
the following categories:
o Controller 30mbar I37P(30)
o Controller 30mbar I3 + (28-30 / 37)
o Regulator 37mbar I3 + (28-30 / 37)
o 50 mbar I3B / P regulator (50)
23