Publicidad
13
13
NAIL
(51 used in this step)
Carefully turn your unit over onto its front edges. Unfold the BACK (G) and lay it over your unit.
Make equal margins along all four edges of the BACK (G). Push on opposite corners of your unit if needed to make it "square".
Fasten the BACK (G) to your unit using the NAILS (1N).
NOTE: Be sure to tap NAILS into the holes that line up over the UPRIGHTS (B and C) and SHELF (F).
NOTE: Perforations have been provided for access through the BACK. Carefully cut out the holes needed.
Fasten the FOOT BRACKET (6E) to the BOTTOM (E). Use three BLACK 9/16" LARGE HEAD SCREWS (1S).
Slide the SUPPORT MOLDINGS (S) onto the FOOT BRACKET (6E). Then, firmly push the CORNER CAP (5E) onto the
SUPPORT MOLDINGS (S).
414239
These holes must line up over
the UPRIGHTS and SHELF.
1N
www.sauder.com/services
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
G
E
6E
S
BLACK 9/16" LARGE HEAD SCREW
(3 used for the FOOT BRACKET)
S
5E
1S
Page 17
Publicidad
