Maintenance - LG WD100C Serie Manual Del Propietário

MAINTENANCE

CLEANING THE WATER INLET FILTERS
If the washer does not fill properly, an error
message will show on the display. The inlet valve
filter screens could be plugged by hard water scale,
sediment in the water supply, or other debris.
NOTE: The inlet screens protect the delicate parts
of the inlet valve from being damaged by particles
that could enter the valves with the water supply.
Operating the washer with these filters removed
could cause a valve to stick open resulting in
flooding and/or property damage.
Cold water inlet
Inlet Filter
1. Turn OFF both water faucets completely.
Unscrew the hot and cold water lines from the
back of the washer.
IMPORTANT: Aftermarket hoses are not guaranteed
to fit or function correctly. Other hoses may not
tighten correctly and could cause leaks. Subsequent
damage to product or property will not be covered
under the terms of the product warranty.
2. Carefully remove the filters from the water
valves and soak them in white vinegar or a lime
scale remover, following the manufacturer's
instructions. Be careful not to damage the filters
while cleaning.
3. Rinse thoroughly before reinstalling. Press the
filters back into place.
4. Before reattaching the hoses, flush the hoses and
water lines by running several gallons of water
into a bucket or drain, preferably with the faucets
wide open for maximum flow.
NOTE: An IE message may blink on the display
when the water pressure is weak or an inlet filter is
clogged with dirt. Clean the inlet filter.
y Unplug the power cord and turn off the faucets
y Do not use the washing machine without the
y If you use the washing machine in an area with
CARE IN COLD CLIMATES
STORING THE WASHER
If the washer will not be used for an extended period of
time and is in an area that could be exposed to freezing
Hot water inlet
temperatures, perform the following steps to
protect the washer from damage.
1. Turn OFF the water supply.
2. Disconnect the hoses from the water supply and
3. Plug the power cord into a properly grounded
4. Add 1/4 gallon of nontoxic recreational vehicle
5. Press the POWER button, then select the Spin
6. Unplug the power cord, dry the tub interior with a
7. Store the washer in an upright position.
8. To remove the antifreeze from the washer
CARE AND CLEANING
WARNING
before cleaning. Failure to do so may cause
electric shock.
inlet filters. If you use the washing machine
without the inlet filters it will cause leaks and
product malfunction.
hard water, the inlet filter may clog due to lime
buildup.
drain water from the hoses.
electrical outlet.
(RV) antifreeze to the empty tub and close the lid.
Never use automotive antifreeze.
Only cycle (see page 20). Press the START/
PAUSE button to activate the drain pump. Allow
the drain pump to run for one minute, then press
the POWER button to shut off the washer. This
will expel some of the anifreeze, leaving enough
to protect the washer from damage.
soft cloth, and close the lid.
after storage, run a complete wash cycle using
detergent. Do not add laundry to this cycle.
23