LG WD100C Serie Manual Del Propietário página 31

30
TROUBLESHOOTING
ERROR CODES (continued)
Problem
The display shows:
The display shows:
The display shows :
The display shows:
The display shows:
The display shows:
The display shows:
Possible Cause
If the rebalancing operation (see
above) is not successful, this error
will be displayed.
The load is too small.
Heavy articles are mixed with
lighter items.
The load is out of balance.
Control error.
Water level is too high due to a
faulty water valve.
The water level sensor is not
working correctly.
A motor error has occurred.
It is time to run the Limpieza de
tina (Tub Clean) cycle.
Pedestal washer is being operated
without a full-size washer.
Stacking switch is not working
properly.
Solutions
The automatic attempt to rebalance the load
was not successful. The cycle has been
paused to allow the load to be manually
adjusted.
Small loads may need additional items to be
added to allow the washer to balance the
loads.
The load may have heavy items loaded with
lighter items. Always try to wash articles of
somewhat similar weight to allow the washer
to evenly distribute the weight of the load for
spinning.
Manually redistribute the load if articles have
become tangled preventing the automatic
distribution from working properly.
Unplug the power cord and contact your
nearest LG service center.
Close the water faucets, unplug the washer,
and call for service.
Close the water faucets, unplug the washer,
and call for service.
Allow the washer to stand for 30 minutes
and then restart the cycle. If the LE error
code persists, call for service.
Empty the tub, add a diluted solution of 1/4
cup bleach to 1 qt. water to the tub, and
select the Limpieza de tina (Tub Clean) cycle.
To skip the Limpieza de tina (Tub Clean) cycle
when alerted, press the cycle selector but-
tons. The message continues to appear for a
few more wash cycles and then disappears
until the next scheduled tub clean.
The pedestal washer will not operate as a
standalone unit. It must be stacked under a
full-size LG appliance.
The stacking switch will not operate properly
if the unit is stacked under a non-LG ap-
pliance, or an LG appliance manufactured
before 2009.