Beurer BM 58 Manual De Instrucciones página 29

If the values between the two arms are significantly differ-
ent, please consult your doctor to determine which arm
should be used for the measurement.
Important: The instrument should only be operated with the
original cuff. The cuff is suitable for an arm circumference
of 22 to 30 cm. A larger cuff for upper arm circumferences
from 30 to 42 cm is available from retailers or the service
address under order no. 163.246.
Correct posture
• Rest for approx. 5 minutes before each measurement.
Otherwise there may be divergences.
• You can perform the measurement either sitting or lying
down. Always make sure that the cuff is on a level with
your heart.
• To carry out a blood pressure measurement, make sure
you are sitting comfortably with your arms and back lean-
ing on something. Do not cross your legs. Place your feet
flat on the ground.
All manuals and user guides at all-guides.com
• In order not to distort the result, it is important to keep still
Measuring blood pressure
• Move the touch screen activation switch to the ON position.
• Put on the cuff as described previously and assume the
• Switch on the blood pressure monitor with the START/
• Before the measurement, the last saved test result is
• The cuff automatically inflates. Cuff air pressure is
• Heart rate, systolic and diastolic blood pressure are dis-
• You can cancel the measurement at any time by press-
29
during the measurement and not talk.
position in which you want to carry out the measurement.
STOP button . After the full-screen display, the most
recently used user memory appears (
the user memory, press the MEM button and confirm
your selection with the START/STOP button
ton is pressed, the most recently used user memory is
automatically used after 5 seconds.
briefly displayed. If there is no measurement in the mem-
ory, the instrument always displays the value .
released slowly. If a tendency towards high blood pres-
sure is already detectable, the cuff is pumped up again
and cuff pressure increased further. As soon as a heart
rate is detected, the heart rate symbol
played.
ing the START/STOP button
screen activation button to OFF.
or ). To change
. If no but-
is displayed.
or by pushing the touch