Solo 530 Manual De Instrucciones página 10

OPERATING AND REGULATING THE MACHINE
Before you start mowing, oil the cutting blade, then start the motor as follows:
•
Engaging the transmission to the wheels and the cutting bar by means of the clutch lever must be carried out with
the motor at a middle r.p.m. and by slowly releasing the lever.
•
When starting to mow, position the accelerator lever at 3/4 or at "MAX" to ensure adequate power.
•
When mowing along a wall or the edge of a sidewalk, be careful to keep a safety distance so that the blade does not
suffer impact. If not, the cutting bar may undergo damage.
•
If the belt slips, loosen the register located on the clutch lever and leave a travel of approximately 5 mm before the
clutch engagement.
•
Adjusting the height of the handles is carried out by moving the knobs securing them on the handlebar support. This
will allow two positions (Fig. 1 Ref. 10).
•
To regulate the motor, read the manual on the motor under "REGULATIONS".
•
For changing the oil and other maintenance operations on the motor (spark plugs, air filter, regulations), refer to the
motor manual provided.
•
NB: To unscrew the oil drain plug of the motor, disassemble the rear cover (Fig. 8 Ref. D).
•
Empty the gearbox of oil by unscrewing the oil drain plug, let the oil drain completely. After screwing back the cap
tightly, fill to the correct level with new oil recommended by the manufacturer.
•
Do not leave the exhausted oil in the environment.
•
Check periodically the oil level and fill in with new oil if necessary.
•
If the grass is not cut in a satisfactory manner despite the adjustments, the blade must be sharpened or replaced.
Follow the instructions on the E.S.M. maintenance sheet.
•
For any mechanical repair, especially during the warranty period, we recommend to go to a specialized repair shop
of the dealer.
•
For transporting convenience, the handles can be disassembled by means of the two knobs (Fig. 1 Ref. 10). The
same is recommended for the cutting bar, which is easily disassembled by removing the special split pin on the bar
support (Fig. 9 Ref. E). Always use gloves and apply the protective strip to the blade.
•
Regularly check that screws are tight. Pay special attention to the screws fastening the bar to its support.
•
Lubricate periodically the crown wheel for the wheel transmission (Fig. 9 Ref. "F").
CAUTION:!!
It is advised not to keep the motor running when the machine is not
being used for its specific purpose
10
-Fig. n° 8-
MAINTENANCE
-Fig. n° 9-