Product Pairing - Chauvet Professional onAir IP PANEL 2 Guía De Referencia Rápida

EN

Product Pairing

If the onAir IP Panel 2 has already been paired with the CRMX™ transmitter, the Signal Strength Indicator on top of the
display will show the strength of the signal. In this case, the onAir IP Panel 2 is ready to work in Wireless mode.
Pairing the onAir IP Panel 2 and a New CRMX™ Transmitter
1. From the onAir IP Panel 2 control panel, go to Wireless Setting > Receive Reset.
2. Select Yes.
3. From the CRMX™ transmitter, press <RESET>. The signal indicator on the transmitter will flash.
4. Once the transmitter has found the onAir IP Panel 2, the signal indicator on the CRMX™ transmitter will
illuminate solid.
5. The display screen on the onAir IP Panel 2 will show the strength of the signal.
CRMX™ operation can be interrupted or inhibited by people or liquid masses, including water or
snow, between the transmitter and receiver. For best results, keep the area between the transmitter
and receiver clear of any liquid masses.
USB Software Update
The onAir IP Panel 2 allows for software update through USB using the built-in USB port. To update the software using
USB flash drive, do the following:
1. Power on the fixture and plug the flash drive into the USB port.
2. Once the flash drive has been detected, the message "Upgrade Firmware" will be displayed. Press <ENTER>.
• If a different message appears on the display, search for the updated software in the Main Menu (Update
Firmware) and select from Only This Unit, Multiple Units, or Other Fixture Type. A list of the software
update files will be displayed.
3. Select the file that needs to be uploaded. The message "Are you sure?" will be displayed. Press <ENTER>.
4. If the selected file is correct, the upgrade will be completed. Restart the fixture.
• If the selected file is incorrect, the upgrade will fail, and the display will go back to the main interface. Repeat
steps 1-3 using the correct file.
The .chl format file needs to be placed in the ONAIR folder in the USB flash drive.
The "Other Fixture Type" option can only be selected for connected products compatible with the
Upload 03 (the first 2 digits of the item code must be 03).
Mounting
Before mounting this product, read the
weight of the product. Mounting clamps sold separately. For our CHAUVET Professional line of mounting clamps, go to
http://trusst.com/products.
Mounting Diagram
Mounting
clamp
3
QUICK REFERENCE GUIDE
Safety Notes. Make sure the mounting clamps are capable of supporting the
Omega
bracket
Safety cable
Secure the safety
cable using the
passageways on
the back of the
product
Junior pin screw
Junior pin
onAir IP Panel 2 QRG Rev. 3