CARE & MAINTENANCE
This television receiver represents a fine example of electronic engineering and construction.
As such it should be treated with care. We offer the following suggestions so you will enjoy this
product for the years to come.
Keep it dry. If water should get on it, wipe if off
immediately. Water contains minerals that can
corrode electronic circuits.
Do not store in hot areas. High temperatures can
shorten the life of electronic devices, damage
batteries, and can even distort or melt certain plastics.
Do not drop your product. This will likely result in
failure to operate. Circuit boards can crack and the
cases may not survive the impact. Handling your
product roughly will shorten its useful life.
Do not use or store in areas of high level of dirt or
dust. The electronic parts may be contaminated or
will wear prematurely.
Do not use harsh chemicals or strong cleaning
solvents to clean your unit. You need only wipe
it with a slightly moist, never wet cloth.
Always make sure any batteries used are fresh and
are of the correct type. Old or almost-dead batteries
are also dangerous.
A worn out battery can leak chemicals which will
damage the electronic circuits.
26
W1320PTVD MIT IC +MTK1389R12197-20.p65
26-27
SPECIFICATIONS
TV SECTION
Receiving Channels
VHF
CH 2 - 4
L
VHF
CH 5 - 12
H
UHF
CH 21- 69
Tuner Type
255 Channel , VS TUNING
DVD SECTION
Laser Wave length
655nm
Laser power :
Class 1
Signal System
PAL/NTSC output
Digital audio output
Coaxial digital output; pin jack
Headphone
Stereo in DVD mode
Mono in TV mode
GENERAL SECTION
AC Power Input
AC 220-240V~ 50 Hz
AC Power Consumption
74W
Speaker
3" 78mm 8ohm x 2
Audio Output
1.5 W + 1.5 W
Dimensions
L398 x W405 x H399 (mm)
Net Weight
11 kg
v
Design and specifications are subject to change without notice.
It is not a toy and not for children under 8 years old
2008/3/31, 下午 02:25
27