Dell PowerEdge R910 Manual Del Usuario página 8

3 Remove the memory risers. See "Removing a Memory Riser" in the
Hardware Owner's Manual.
4 Press the two release tabs until the memory module cover is unlatched and
lift it in the direction of the arrow. See Figure 1.
5 Press the ejectors on the memory module socket down and out, as shown
in Figure 3-9 in the Hardware Owner's Manual.
6 Align the memory module's edge connector with the alignment key of the
memory module socket, and insert the memory module in the socket.
NOTE:
The memory module socket has an alignment key that allows you to
install the memory module in the socket in only one way.
7 Press down on the memory module with your thumbs to lock the memory
module into the socket.
When the memory module is properly seated in the socket, the ejectors on
the memory module socket align with the ejectors on the other sockets
that have memory modules installed.
Repeat step 5 through step 7 of this procedure to install the remaining
memory modules. See Table 3-1 and Table 3-2 in the Hardware Owner's
Manual.
8 Press the four tabs and close the memory module cover. See Figure 2.
9 Install the memory risers. See "Installing a Memory Riser" in the Hardware
Owner's Manual.
10 Close the system. See "Closing the System" in the Hardware Owner's
Manual.
11 Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.
12 Press <F2> to enter the System Setup program, and check the System
Memory setting on the main System Setup screen.
13 The system should have already changed the value to reflect the newly
installed memory.
14 If the value is incorrect, one or more of the memory modules may not be
installed properly. Repeat step 2 through step 13 of this procedure to
ensure that the memory modules are firmly seated in their sockets.
8
Information Update
All manuals and user guides at all-guides.com