Allen-Bradley 2711P-RAK7 Instrucciones De Instalación página 6

6 Adapter Kit for PanelView Standard and PanelView "e" Terminal Cutouts
Inside of Panel or Enclosure
Nut and
Washer
2. Mount the rear adapter plate to the front adapter plate studs from the back
of the panel, flat side of rear adapter plate towards back of enclosure.
Use the 8, 10 or 12 nuts and flat washers to fasten the rear adapter plate to
the studs.
3. Using the torque wrench, tighten the nuts to not more than 1.92 Nm
(17 lb-in) to maintain a NEMA Type 4X rating.
Do not overtighten.
Publication 2711P-IN010C-MU-P - March 2007
Front Adapter Plate
Front of Panel or Enclosure
Rear Adapter Plate
with 12 holes