Bosch LC258TC60 Instrucciones De Montaje página 10

Prior to installation
For optimum extractor hood efficiency:
❑ Short, smooth air exhaust pipe.
❑ As few bends in the pipe as possible.
❑ Diameter of pipe to be as large as
possible and no tight bends in pipe.
If long, rough exhaust-air pipes,
many pipe bends or smaller pipe
diameters are used, the air extraction
rate will no longer be at an optimum
level and there will be an increase in
noise.
❑ Round pipes:
We recommend
Internal diameter: 150 mm (at least
120 mm).
❑ Flat ducts must have an internal cross-
section that equates to that of round
pipes.
There should be no sharp bends.
l 120 mm approx. 113 cm
l 150 mm approx. 177 cm
❑ If pipes have different diameters:
Insert sealing strip.
❑ For exhaust-air mode, ensure that
there is an adequate supply of fresh air.
Connecting a l 150 mm exhaust-air
pipe:
❑ Mount the pipe directly onto the air
outlet on the hood.
Connecting a l 120 mm exhaust-air
pipe:
❑ Place the reducing connecting piece
onto the air connecting piece – Fig. 3 –
and fasten the exhaust pipe to it.
❑ Attach the exhaust-air pipe to the
reducing connector.
10
Preparing the wall
❑ The wall must be flat and perpendicular.
❑ Ensure that the wall is capable of
Weight in kg:
2
2
LC258TC60
DWT126851
We reserve the right to construction changes within the
context of technical development.
providing a firm hold for mounting
screws and plugs.
Exhaust
air
28
28