Parts List; Installation To Wood Stud Wall - PEERLESS PARAMOUNT PA730 Instalación Y Ensamblaje

Before you begin, make sure all parts shown are included with your product.
Parts may appear slightly different than illustrated.

Parts List

Description
AA wall arm assembly
A M4 x 12 mm phillips screw
B M4 x 20 mm phillips screw
C retaining spacer
D #14 x 2.5" wood screws
E 5 mm allen wrench
F concrete anchor
G cable ties
H cable tie anchor
I 3/16" allen wrench
J 8-32 x 1/4" flat head screw
AA

Installation to Wood Stud Wall

Using a stud finder, locate and mark the edges of the wood stud used in mounting this product. Use of an edge to
1
edge stud finder is highly recommended. Use a level to draw a vertical line down the center of the stud. Use wall
plate as template to mark center of holes along the vertical line. Drill two 5/32" (4 mm) dia. holes 2.5" (64 mm)
deep. Attach wall arm assembly (AA) to wall using two #14 x 2.5" flat head wood screws (D) as shown in figure
1.1.
WARNING
• Installer must verify that the supporting surface will
safely support the combined load of the equipment
and all attached hardware and components.
• Tighten wood screws so that wall plate is firmly at-
tached, but do not overtighten. Overtightening can
damage the screws, greatly reducing their holding
power.
• Never tighten in excess of 80 in. • lb (9 N.M.).
• Make sure that mounting screws are anchored into
the center of the stud. The use of an "edge to edge"
stud finder is highly recommended.
All manuals and user guides at all-guides.com
PA730 PA730-S
Qty. Part # Part #
1 095-P1628 095-4268
4 504-9013 504-2014
4 504-9020 504-2013
4 590-5005 590-5003
2 520-1202 520-2165
1 560-9640 560-9640
2 590-0320 590-0320
2 560-9711 560-2004
2 590-1290 590-1290
1 560-0071 560-0071
2 520-1622 520-2622
G
3 of 20
A B C
E
I
H
J
WOOD STUD WALL
AA
D
ISSUED: 06-18-07 SHEET #: 095-9269-5 06-05-09
D F
Skip to step 2.
fig. 1.1