Built-In Installation; Operation; Temperature Control - Haier HRF-225 Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 54
Preparation
Preparation
Preparation
Preparation
Preparation

Built-in installation

Built-in installation
Built-in installation
Built-in installation
Built-in installation
1. Ensure that the doors of the kitchen unit and the
refrigerator are of the same opening direction. (Take
the right-opening door as an example)
2. Fix the joint sockets to the freezer and refrigerator
doors with the provided screws (Figure 1).
3. Move the refrigerator into the kitchen unit,
ensuring the left side panel of the refrigerator as
close as possible to the wall. (Figure 2)
4. Insert the connecting pad into the joint socket
and then fix the connecting pad on the door of the
kitchen unit with a margin of 20-22mm. (Figure 3)
5. Properly place the refrigerator with a 3-4mm
space between the left side to the wall, ensuring
that the doors of the refrigerator and the kitchen
unit can be easily opened and closed, and the
connecting pad is correctly settled in the joint
socket.
6. Fix the upper and lower stiffeners to the upper
connection and base panel. The screw holes shall
be plugged with the plastic stoppers. (Figure 4)
7. Fill the left gap of the kitchen unit with the gasket.
(Figure 5)
8. Remove the screws and the hole stoppers on the
left of the middle connection, and fix the connecting
pivot to the refrigerator with one end in the hole
which was plugged by the stopper and the other
end to the inside wall of the kitchen unit. (Figure 6)
7
All manuals and user guides at all-guides.com
Joint socket
(Figure 1)
C
Connecting pad
(Figure 2)
(Figure 3)
Plastic stopper
door gasket
(Figure 4)
(Figure 5)
(Figure 6)

Operation

Operation
Operation
Operation
Operation
1 Connect the refrigerator to the
power supply.

2 Temperature control

The refrigerator shall be placed in an area
with an ambient temperature of over 16℃.
Temperature in refrigerator can be controlled
by the thermostat ①. There are 7 options, 1,
2, 3, 4, 5, 6 and 7, for selection. With the
value increasing, the temperature goes down
accordingly. Information in the diagram can
be taken as the reference for selection of
temperatures.
3 Loading the refrigerator with
food
Load the refrigerator with food two or three
hours after the refrigerator is turned on.
Caution: Some time will be required for the refrigerator to reach the set level when
temperature adjustments are made. The length of this period is determined by difference
in the existing and set temperatures, the ambient temperature, the frequency with which
the door is opened and closed and the amount of food in storage.
thermostat T
recommended
Prevailing ambient
positions
temperature
1 - 3
Ambient temperature≥32℃
3 - 5
Ambient temperature16~30℃
5 - 7
Ambient temperature≤16℃
8

Publicidad

Tabla de contenido
loading

Tabla de contenido