Repeat Playback; Programmed Playback - Roadstar CDR-4200CD Manual De Instrucciones

• Discs should be returned to their cases after use. This avoids serious scratches that
could cause the Laser pickup to skip.
• Do not expose discs to direct sunlight, high humidity, or high temperatures for extended
periods. Long exposure to high temperatures can warp the disc.
• Do not stick paper or write anything with a ballpoint pen on the label side of the disc.
CD PLAYBACK
Loading and Unloading Compact Discs
1. Set the Function Selector (1) to the CD Position.
2. Open the disc compartment by lifting the CD OPEN corner (8).
3. When the door has opened, remove a disc from its case and place it carefully in the
compartment with the label side facing up. Locate 3" discs, on the central spindle in the
compartment.
4. Close the door by pressing on the corner of the CD door.
The total number of tracks appears on the display. Press PLAY/PAUSE/ Button (II ) (11)
During playback, the actual track appears.
5. Adjust the VOLUME control to your desired listening level.
6. To stop playback temporarily, press the PLAY/PAUSE (II ) button (11) once. The Play
indicator will flash on the display. Press the PLAY/PAUSE (II ) button again to resume
playback.
7. To stop playback, press the STOP (10) button once.
8. To switch OFF the unit select OFF with the Function Selector (1).
Notes:
• When the CD door is accidentally opened during playback, "OP" will appear on the
display.
• Wait until the disc is fully stopped before opening the CD (8) compartment.
• This unit can play 3" (8cm) single CDs without an adaptor.
All manuals and user guides at all-guides.com
5
English
6
English
LOCATING A PARTICULAR TRACK OR POINT OF THE TRACK
1. Press the SKIP - (17) button once to go back to the beginning of the current track.
2. Press the SKIP - button repeatedly to go back to previous tracks.
3. Press the SKIP + (12) button repeatedly to go to next tracks.
4. Press and hold either SKIP + or SKIP - button to search backwards or forwards, at high
speed, a particular point of track.
Note: Low level audio will be heard during the search process to assist in locating the
correct point in the track.

REPEAT PLAYBACK

1. Press the PLAY/PAUSE button (11).
2. To repeat the same track, press the REPEAT button (15) once. The indicator
"REP" will flash on the display.
The CD will start single repeat playback until STOP button (10) is pressed. Press the
REPEAT button 2 times more to cancel single repeat. The indicator disappears from
the display.
3. To repeat the entire disc, press the REPEAT button twice. "REP ALL" will appear on the
display. Press the REPEAT button once more to cancel Repeat All function.

PROGRAMMED PLAYBACK

1. Press the PLAY/PAUSE button (11) and after 5 seconds the STOP button (10).
2. Press the PROGRAM button (16). The track number "P01" will appear and flash on the
display indicating the first selection.
3. Press SKIP - or SKIP + button to select the desired track to be programmed. The track
number which will be programmed will appears on the display.
4. Press once the PROGRAM button to enter the track into memory. "P02" will appear.
5. Repeat the steps 3 and 4 to program up to 20 tracks.
6. Press PLAY/PAUSE (II) button (11) once to start programmed playback.
7. To cancel programmed playback, press the STOP button (10) twice.
Note:
During program playback, if you wish to repeat the entire programmed playback,
press the REPEAT button (15) repeatedly until the "REP" indicator appears on the
display.