Technoline WS 9140 Manual De Instrucciones página 40

HOW TO INSTALL AND REPLACE BATTERIES IN THE TEMPERATURE
TRANSMITTER
The temperature transmitter uses 2 x AA, IEC LR6, 1.5V battery. To
install and replace the batteries, please follow the steps below:
1.
2.
3.
Note:
In the event of changing batteries in any of the units, all units need to
be reset by following the setting up procedures. This is because a security code is
assigned by the transmitter at start-up and this code must be received and stored by the
Temperature station in the first 3 minutes of power being supplied to it.
Remove the battery compartment cover at the back of the
transmitter.
Insert the batteries, observing the correct polarity (see marking).
Replace the battery compartment cover on the unit.
39