Dimensions; Installation Area; Checklist For Installation - Bosch Nexxt 800 Serie Manual De Operación, Cuidado Y Instrucciones Para La Instalación

2. Wrench for leveling.
3. Clamp for drain hose.
On the back of the washer:
- hot and cold water connections
- power cord with label warning to
remove transportation bolts

- two AQUASTOP hoses (remove
hoses from clips on back of
washer for installation)
Useful tools
The following tools are helpful:
1. Flat head screwdriver.
2. Socket wrench (1/2" / 13 mm).
3. Closed wrench (1/2" / 13 mm).
4. Bubble Level.
All manuals and user guides at all-guides.com

Dimensions

a = 27.0 inches (686 mm)
b = 30.7 inches (780 mm)
c = 37.0 inches (940 mm)
d = 16.0 inches (407 mm)
Door opening angle 180°
Approx. weight = 220 lbs (100 kg)

Installation area

d WARNING
Never ground the washer to plastic
plumbing lines, gas lines or hot
water pipes.
This appliance must be installed on
a solid floor and well leveled due to
the higher spin speeds available. If
installing the machine on a wood
floor over a basement or on a
second floor, the floor may need to
be reinforced. Sound, vibration, and
risk of walking" will be affected
depending on the structure and
stability of the floor surface where it
is installed.
If the washing machine is to be installed
on a weak wood floor consider the
following:
Soft floor surfaces, such as
q
carpets or surfaces with foam
backing, are not suitable. If
possible, place the washing
machine in a corner of the room.
Screw a water resistant wooden
q
board (at least 3/4" thick) to the
floor.
Secure the feet of the washing
q
machine with holding brackets.
Order the holding brackets (set)
from Bosch Customer Service
(WMZ 2200).
Units are not designed to be
q
stacked.
Units are not designed for under
q
counter installation
Pedestal Mounting Kit
8 inch pedestal accessory number
WTZ 1295 for solid white color
WTZ 1295S for solid silver color
WTZ 1295P for duo tone silver/white
15 inch pedestal accessory number
WTZ 1500 for solid white color
WTZ 1500S for solid silver color
WTZ 1500C for duo tone
champagne/white
WTZ 1500P for duo tone silver/white
If mounting the washer on the pedestal
follow the instructions supplied with the
pedestal.
i Install pedestal prior to
removing transport bolts.
Closet
If installing the washer in a closet,
observe the minimum distances
according to the following table:
Minimum Installation Clearances
Sides 1/4" (6 mm)
Top 12" (3O5 mm)
Rear 2.5" (64 mm)
Front 1/4" (6 mm)
Ventilation:
Top: 48 sq. in (310 sq. cm),
Bottom: 24 sq. in (155 sq. cm)
Checklist for
Installation
completely remove 4 shipping bolts
and move the washer into place
connect the water supply lines and
drain pipe
connect the electrical power
slide the washer into its final location
level the washer as low as possible
before first use, run a cleaning cycle
Closet
Page
8
9
10
10
10
13
7